Need Help Light Chaser - Bullfighting and Remote Control Skills

[billvitez96]

Further exploring the HEXA and its functionality I have a few questions regarding 3 Skills:

1. The Light Chaser Skill requires a TSL2561 Luminosity Sensor Module. Simple enough to purchase but I cannot find instructions regarding proper installation. There is an icon next to “Quick Instructions” but nothing happens when I try to click on it. Where can I find instructions? Or is it just a simple matching of the Pin Outs?

2. When trying to run the Bullfighting Skill I get a message in Chinese in white font on a black rectangular popup. The Skill does not run and I do not read or speak Chinese. How can I get this Skill to work?

3. The RF Control Skill requires a 27MHz Tx/Rx and GPIO Interface. Again, simple to acquire but there are no instructions for how to set the hardware up.

Any help would be greatly appreciated.

Thanks!
Bill

[billvitez96]

UPDATE on Subject #1.

I offer this to assist others who are interested in using the Light Chaser Skill.

I was able to match the pin outs on the TSL-2561 Module that I purchased with those on HEXA’s Hardware Interface (my Module is 3V). After installing the Module and Powering ON, the Light Chaser App opened and my HEXA now seeks out and moves towards bright light sources.

To make this easier, I have attached an enlarged image of my TSL-2561 Module (bottom of PCB where the silkscreen pin out labels are) with the proper wiring to the HEXA. The Module is only 18 X 14mm. I also included a separate color coded HEXA Hardware Interface diagram to assist to identify proper Dupont wire connections…

I still require assistance with #2 and #3 and I’ll add a #4 Rock and Run which also does not load.

Please help!
Thanks!
Bill